How it's calculated
- Gross area = length × width
- Net area = gross area − area not tiled
- Tile module (ft²) = (tile length + joint) × (tile width + joint) ÷ 144 [inches]
- Tiles = net area × (1 + waste% ÷ 100) ÷ tile module → round up
- Boxes (tiles per box) = tiles ÷ tiles per box → round up
- Boxes (area per box) = net area × (1 + waste%) ÷ coverage per box → round up
Each tile occupies its own face plus one grout joint in each direction, so we divide the area by the tile-plus-joint module rather than the bare tile face. On small tiles with wide joints this noticeably lowers the count.
Waste is applied to area before rounding, then tiles and boxes are each rounded up because you can't buy a fraction of either. When your box label lists area instead of a tile count, we size boxes from area so results match the label.
Worked example
12 ft × 10 ft floor, 12 × 12 in tile, 1/8 in joint, 10% waste, 10 tiles per box
- Area = 12 × 10 = 120 ft²
- Module = 12.125 × 12.125 ÷ 144 = 1.0209 ft²
- Tiles = 120 × 1.10 ÷ 1.0209 = 129.29 → 130 tiles
- Boxes = 130 ÷ 10 → 13 boxes
Figures generated by the same functions that power the calculator and covered by automated tests.
Assumptions & limitations
- Floor is a rectangle (split L-shapes into rectangles and add them).
- Waste default 10%; diagonal or herringbone layouts often need 15% or more.
- Metric inputs are converted to feet/inches internally, then results shown in both systems.
- Does not model layout pattern, cut planning, borders or wall tile.
- When you enter area per box, coverage is taken from your label; we do not look up products.
- When you enter tiles per box, the box-area figure is bare tile face area, not a claim about manufacturer printed coverage.
Frequently asked questions
Why does the grout joint change the tile count?
Every tile is laid with a gap. With 12 in tiles and a 1/8 in joint, each tile effectively covers 12.125 in square, so slightly fewer tiles fill the same floor. On mosaics with wide joints the difference is larger.
How much extra tile should I buy?
10% is a common starting point for straight layouts. Diagonal, herringbone and rooms with many corners usually need more. Keeping a few spare tiles from the same production lot also helps with future repairs.
My box lists square feet instead of a tile count. Which do I use?
Switch 'Box label shows' to area per box and enter the coverage printed on the box. The calculator then sizes boxes from area, which matches how the manufacturer rated the box.
Should I subtract the area under cabinets?
Many installers skip permanent cabinets and islands to save tile. Enter that footprint as 'area not tiled'. Leave it at zero if you plan to tile under appliances.