How it's calculated
- Net area = non-overlapping additions − contained exclusions
- Paver packs = net area × (1 + waste%) ÷ printed pack coverage → supplier rounding
- Layer loose-order volume = net area × confirmed depth ÷ 12 × entered loose-order factor
- Joint bags = installed area ÷ printed coverage range → round up conservatively
- Edge pieces = confirmed exposed length × (1 + cutting waste%) ÷ usable piece length → round up
The planner combines the tested DCL-010 rectangle engine with the DCL-002 supplier rounding engine. It never chooses a layer depth, density or exposed edge length for you.
Joint sand uses the conservative end of your entered product coverage range because paver shape, joint width and depth affect coverage.
Worked example
128 ft² multi-zone math fixture — not a recommended assembly
- Zones: 12×10 + 4×3 − 2×2 = 128 ft²
- Pavers: 128 × 1.10 ÷ 12.5 ft²/pack → 12 packs
- Base: 128 × 4/12 × 1.15 = 1.817 yd³ → 2 yd³ at quoted minimum
- Bedding: 128 × 1/12 × 1.10 = 0.435 yd³ → 0.5 yd³ at quoted step
- Joint sand: 60–120 ft²/bag → 2–3 bags; buy 3 conservatively
- Edging: 40 ft × 1.05 ÷ 8 ft/piece → 6 pieces
Figures generated by the same functions that power the calculator and covered by automated tests.
Assumptions & limitations
- Ground-level pedestrian residential patio using non-permeable sand-set concrete pavers.
- You confirmed the selected layer depths, materials, drainage direction and elevations outside this calculator.
- Pack coverage, density, yield factors and supplier rules come from your product data and quote.
- Required material and purchased quantity remain separate throughout the BOM.
- Not for vehicles, permeable systems, overlays, porcelain slabs, rooftops, steps, pools, retaining walls, fire features or structural work.
- No soil, frost, drainage, grading, permit or code design is performed.
- Geotextile, drainage hardware, excavation/spoil, edge fasteners, equipment and labor are excluded.
- Contact 811 before excavation and follow the requirements for your state and marked utilities.
Sources
- CMHA — Construction of Interlocking Concrete Pavements
- CMHA — Edge Restraints for Interlocking Concrete Pavements
- Belgard — Standard Paver Installation Quick Reference
- 811 Before You Dig — Homeowner guidance
Yields are nominal approximations; your package label is authoritative.
Frequently asked questions
Does this tell me how deep the base should be?
No. Base thickness depends on traffic, soil, drainage, moisture, climate and the selected system. Confirm it for your site, then enter it here.
Why do I enter an exposed edge length?
Area alone cannot tell which edges meet a wall, curb or other restraint. Measure only the edges that need purchased restraint.
Why is joint sand shown as a range?
Product coverage changes with paver size, joint width and depth. Enter the printed range; the shopping count uses the conservative end.
Can I use this for a driveway?
No. Vehicle loads and structural design are outside this planner's approved scope.