How it's calculated
- Gross area = wall length × wall height
- Net area = gross area − openings
- Module (ft²) = (brick length + joint) × (brick height + joint) ÷ 144
- Bricks = net area ÷ module × (1 + waste% ÷ 100) → round up
We treat each brick as occupying its face plus one mortar joint horizontally and vertically, the standard approach for estimating stretcher-bond veneer. Openings are subtracted from the wall area before counting.
This is a non-structural estimate. It does not cover multiple wythes, headers, columns, footings, lintels, reinforcement or load-bearing design — consult a qualified professional and local code for structural masonry.
Worked example
20 ft × 8 ft wall, 21 ft² of openings, modular brick, 3/8 in joint, 5% waste
- Net area = 160 − 21 = 139 ft²
- Module = 8 × 2.625 ÷ 144 = 0.1458 ft² → 6.857 bricks/ft²
- Bricks = 953.14 × 1.05 = 1,000.8 → 1001
Figures generated by the same functions that power the calculator and covered by automated tests.
Assumptions & limitations
- One wythe (single layer) of brick laid in running/stretcher bond.
- Default 5% waste for breakage and cuts; increase for complex walls.
- Mortar quantity is not estimated because bag yield varies by product and mix.
- Multiple wythes, double walls and cavity walls are not covered (multiply only if you understand your wall build-up).
- No mortar, sand or cement quantities — check the product's stated yield.
- Patterns with headers (Flemish, English bond) use more bricks.
Frequently asked questions
How many modular bricks are in a square foot?
With a 7 5/8 × 2 1/4 in brick and a 3/8 in joint, the module is 8 × 2 5/8 in, which works out to about 6.86 bricks per square foot of wall face.
Does this work for a double-brick or structural wall?
No. It counts one layer of face brick only. Multi-wythe and load-bearing walls involve headers, ties, reinforcement and engineering decisions this tool doesn't make.
Why don't you estimate mortar bags?
Mortar yield depends heavily on the product, mix ratio, joint profile and brick type. Rather than invent a number, we suggest using the yield printed by the mortar manufacturer or asking your supplier.
Can I use metric bricks?
Yes. Switch to metric and enter the brick face in centimetres, for example 21.5 × 6.5 cm with a 1 cm joint for a UK standard brick.